论文代写：路由器

论文代写：路由器

EIGRP（增强型内部网关路由协议）是一个协议，基于其以前的版本即IGRP路由。在Somerset中部，EIGRP配置完成Somerton街之间，康普顿Dundon和Langport路由器在自治系统（AS），在每一个路由器的应用。
的网络地址和子网方案已被用于这种网络是11.12.14.0/24允许254台主机，其中包括8位的使用。为了满足基础设施的要求，可能需要将网络IP添加到子网中。
这种设计导致了IP地址的浪费的消除和允许发展计划就未来的使用（mirzahossein et al，2013）

配置EIGRP

EIGRP可以配置基层本身和两步过程之后为目的的配置使中央萨默塞特全面运作。
用于配置的第一个命令是（config）#路由器EIGRP 123和网络地址，需要宣传的是（config-if）#网络11.12.13.0。

为了在萨默顿路由器EIGRP配置，使用下面的命令：

萨默顿# config t
萨默顿（config）#路由器EIGRP 123
萨默顿（config-if）#网络11.12.13.0
萨默顿（config-if）#退出

除此之外，它还需要在兰波特路由器是由类似的命令取代“萨默顿’与’ Langport ‘做配置EIGRP。

路线图
路线图的目的是在路由信息的过程中对输入和输出进行控制。除此之外，它还可以通过实现某些条件来修改路由条件。因此，路由图有助于将信息从一个协议路由到另一个协议。此外，它还可以用于控制信息的路由方法。

结论
该报告详细说明了利用OSPF和EIGRP网络环境内中央萨默塞特网络设计的目的。因此，本报告清楚地解释了功能萨默塞特系统的重要性。路由信息的过程也进行了研究。

论文代写：路由器

EIGRP (Enhanced Interior Gateway Routing Protocol) is a routing protocol which is based on its previous version i.e. IGRP. In the central Somerset, the configuration of EIGRP is done between the Somerton, Street, Compton Dundon and Langport routers where the Autonomous System Number (AS) which is used across every router.
The Address of the network and the Subnet Scheme which has been used for this kind of network is 11.12.14.0/24 and allows the use of 254 hosts each of which consists of 8 bits. In order to meet the infrastructure requirements the network IP may be required to be added to the subnet.
This kind of design led to the elimination of the wastage of the IP address and permitted the use of the development plans with respect to the future (Mirzahossein et al, 2013)

Configuration of EIGRP

The EIGRP can be configured at the basic level itself and the two step process is followed for the purpose of the configuration so as to make the Central Somerset fully operational.
The first command used for the configuration is the (config) # Router EIGRP 123 and the network address which is needed to be advertised is (Config-if) # Network 11.12.13.0.

In order to configure EIGRP on the Somerton router, the following commands are used:

Somerton # config t
Somerton (Config) # Router EIGRP 123
Somerton (Config-If) # Network 11.12.13.0
Somerton (Config-If) # Exit

Other than this, it is also required to configure the EIGRP on the Langport Router which is done by the similar commands by replacing the word ‘Somerton’ with the ‘Langport’.

Route Maps
The purpose of route maps is to enable a control over the input and output during the process of routing the information. In addition to this, it can be also used for modifying the conditions for routing by implementing certain conditions. Thus, route maps helps for the purpose of routing the information from one protocol to the other. Furthermore, it can also be used for controlling the method of routing of the information.

Conclusion
In this report the detailed explanation has been provided for the purpose of designing of Central Somerset network by using the OSPF and EIGRP within the networked environment. Thus, this report clearly explains the importance of function Somerset system. The process of routing the information has also been studied.